I was playing with my old Airmap 500 that has not actually seen any 'active'
service since I purchased it.


Anyway, I entered a simple route A -> B -> C -> D.

When I select 'Navigate Route' , it would appear that it is trying to go
directly to point D without going via A B & C. Is this normal or am I
doing something wrong.

Lost the manual by the way :(

B2Z

Bravo,

> Lost the manual by the way :(
>

So download it from www.lowrance.com. While you're at it, check for the
latest firmware for your Airmap 500. Once you're sure you have that,
let's try again.

--
Thomas Borchert (EDDH)

Done both and still none the wiser


"Thomas Borchert" > wrote in message
...
> Bravo,
>
>> Lost the manual by the way :(
>>
>
> So download it from www.lowrance.com. While you're at it, check for the
> latest firmware for your Airmap 500. Once you're sure you have that,
> let's try again.
>
> --
> Thomas Borchert (EDDH)
>

Bravo,

> Done both and still none the wiser
>

Hmm. I've seem this happen with one single customer (we're a German
pilot shop) and have never been able to reproduce it. Have you tried
calling Lowrance support?

One last idea: There's a setting somewhere that says how close you need
to be to a waypoint for the arrival alarm to go off. That should be at
a half or quarter mile.

--
Thomas Borchert (EDDH)